25
Jøtul Chimney system
Rain collar
Place the vulcanising tape over the roof seal and mod-
ule pipe in order to seal the gap that arises. The tape
must be stretched so that there is pressure around the
entire chimney.
The tape is secured by overlapping the ends and by
having
at least 20 mm overlapping
at the joint.
Thread the rubber moulding onto the module pipe,
and ensure that the longest part is located against the
casing.
Assemble the rain collar and the rubber moulding on
the module pipe above the vulcanising tape.
Install the rain collar as close to the vulcanising tape
as possible without compressing the vulcanising tape.
Adjust the height and location of the rain collar.
Then secure the mounting screw in the lower joint on
the rain collar. This must be done before the attach-
ment bolt has been completely tightened, to ensure
that the rain collar is not pulled crooked, leading to
leaks. Finally tighten the attachment bolt as far as
possible without affecting the shape of the module
pipe.
Rain/top protection (not Combi)
Place the rain/top protection on the uppermost mod-
ule pipe, secure with the three enclosed screws, as
illustrated. The protection must be installed so that it
is level with the inner pipe.*
Open the rain/top protection and place the rain
protector piece in the flue pipe. Close the rain/top
protection and check the installation.
*The inner pipe may protrude max. 10 mm above the
top protection.
Festebolt
Monteringsskrue
Max 10 mm
Regnstuss
3 x
NVI 2000 - ROOF HOOD
Module pipe
at least 20 mm
Vulcanising tape
Rubber
moulding
Rain collar
Vulcanising tape
Roof seal
Attachment
bolt
Mounting screw
Rain protector
piece
Max. 10 mm
