13
4. Push in the gas control knob (B) as far as possible and
hold it in. Simultaneously, push in the ignition knob (A)
until the spark ignites the pilot flame located to the
right rear corner of the burner..
5. Continue to hold in the gas control knob for approx. 20
seconds after the pilot flame has been lit. Then let go of
the knob. It should pop back out and the pilot flame
should remain lit.
If the pilot flame goes out, repeat Steps 1-5.
If the pilot light goes out intentionally or unintentionally,
it should not be relit within 3 minutes.
*NO
*NO
*NO
*NO
*NOT
TT
T
TE:
E:
E:
E:
E: If the gas control knob does not pop out when
released, call for service.
**NO
**NO
**NO
**NO
**NOT
TT
T
TE:
E:
E:
E:
E: If the pilot flame does not remain lit after several
attempts, turn the gas control knob to OFF and call for
service.
Lighting the Main Burner
1. Turn the gas control knob clockwise to “ON”.
2. Push the ON/OFF switch at the rear of the appliance to
“ON”.
NO
NO
NO
NO
NOT
TT
T
TE:
E:
E:
E:
E: When the appliance is used for the first time,
condensation may form in the firebox. Some smoke may
also appear from the appliance during the initial hours,
due to the burning off of paint and lubrication used in the
production process. See section Odors when using the
stove for the first time.
Adjusting the Heat Setting
Heat and flame size can be adjusted by turning the
regulator knob (C) marked “HI, LOW”, which is located next
to the gas control knob (see fig.
21)
. Maximum flame size
provides maximum heat. Make sure the appliance has
been operating for at least 30 minutes before adjusting
the flame.
Turning Off the Appliance
Push the ON/OFF switch at the rear of the appliance
to”OFF”. The pilot flame will continue to burn. In order to
fully extinguish the appliance, push in the gas control knob
(C) (fig.
21
) a little and turn clockwise to”OFF”. Do not use
force.
E
A
C
D
B
Maintenance
The complete installation, which includes the gas supply,
the actual appliance and the vent system, must be in-
spected annually. The inspection must be carried out by
qualified service engineer.
External Maintenance
Painted products may change color after some years of
usage. The surface should be cleaned and brushed free of
any loose particles before new stove paint is applied.
Enameled products must only be cleaned with a dry cloth.
Do not use water or soap. Enamel surfaces stain easily
when hot. Use only a soft damp cloth and only on cold
surfaces.
Figure 21. Valve Controls.
Figure 22. Burner Controls.
ON
TSTAT
OFF
