— 13—
appliances (lamps) plugged into the Clapper Plus base unit,
but when both are pressed at the same time, they are used
to set the channels on the Remote and also send a signal to
the Clapper Base unit to set its channel.
SETTING CLAPPER PLUS CHANNELS
STEP BY STEP INSTRUCTIONS:
1) Plug the Clapper into the wall socket where you want
to use it.
2) Place the Home/Away switch into the AWAY position.
In the Away Mode:
a. The right LED will flash
b. and appliances or lamps plugged into the Clapper
they will turn on for 10 seconds.
3) Set the channel by pressing and releasing both buttons
on the Remote Control at the same time. Press both
1, 2, 3 or 4 times depending on the Channel number
you want to set.
a.
NOTE:
When pressing the buttons on the remote,
hold them down until you see all three Red lights on
the Clapper Plus turn on, then release the buttons.
4) Place the Home/ Away switch to the HOME position
and you are done.
