Joovy Qool 800X, Инструкция по эксплуатации

Страница: 3 / 10

5 Front Wheel Swivel Locks
• The front wheels can be set to “lock” by pushing down on the locking button and “swivel” by pushing down on the locking button a second
time. See Figure 5.1.
9 Operating the Canopy
• The canopy can be adjusted to be fully opened or closed. See Figure 9.1.
• The canopy can be made larger by unzipping the extension and pulling the canopy open. See Figure 9.2.
!
WARNING
Possible pinching hazard - Be careful of the side hinges when opening and closing the canopy.
!
WARNING
ALWAYS set BOTH wheels to the same mode before using stroller.
6 Rear Wheel Brakes
• Always engage rear brakes before placing child in or removing a child from the stroller.
• The rear wheel brakes can be engaged by pushing down on the brake lever and released by pulling up on the brake lever. See Figure 6.1.
NOTE: Rock the stroller back and forth to ensure the brake is fully engaged.
!
WARNING
Always engage the parking brake when the stroller is not being pushed so that it will not roll away.
Never leave stroller unattended, especially on a hill or incline, as the stroller may tip over or slide.
3 Installing/Removing Rear Wheels
• Install a rear wheel by sliding the axle into the hole in the wheel hub until it clicks into place. See Figure 3.1. Pull on the wheel to ensure it
is secure.
• Repeat this step for the other wheel.
• To remove the rear wheels, press the release buttons on the rear axle bar and pull the wheels from the stroller. See Figure 3.2.
4 Installing the Front Wheels
• Tilt the stroller so it is resting on the rear wheels and the handlebar.
• Slide one front wheel onto the front wheel post until it clicks in place. See Figure 4.1.
• Repeat for other front wheel.
• Pull on the wheels to ensure they are installed properly.
• To remove the front wheels, press the release button on the front of the wheel and pull it away from the stroller. See Figure 4.2.
7 Unfolding the Seat
To unfold the seat, pull up on the recline mechanism and pull up on the seatback until it unfolds and locks into position. See Figure 7.1.
8 Installing/Removing the Seat
The seat can be placed on the stroller facing forward or backward.
• Place the seat on the stroller so that the male brackets on the bottom of the seat line up with the female brackets on the stroller frame.
See Figure 8.1.
• Push down on both sides of the seat until both brackets snap into place. Pull up on the seat on both sides to ensure it is secure.
• To remove the seat from the stroller, squeeze upward on both triggers found on the seat above the brackets and pull the seat off the stroller.
See Figure 8.2.