Caboose Ultralight Instruction Manual
!
WARNING
ALWAYS secure the safety latch on the side of the stroller when it is in the
unfolded use position. This will prevent collapse of the stroller should the
handle trigger locks be accidentally opened.
Unfolding the Stroller
• Keep children away from stroller while unfolding.
• Position the stroller with the handle bar closest to you.
• Release the locking latch located on the right side by lifting the lever off of the extended
rivet. See Figure 2.
• Lift up slightly on the handle of the stroller. Then place one foot onto the rear platform and
pull up and back on the handle until both side frame bars snap into their locking positions
in the frame.
CAUTION: While unfolding the stroller, be careful to keep your fingers from being pinched
by moving parts.
NOTE: Remove packing foam from rear frame assembly to ensure stroller locks in the
open position.
• Lock the safety latch on the lower left side of the stroller by pushing the lever down over
the extended rivet. See Figure 3.
• Ensure that the stroller is completely opened and the safety latch is secured before ANY
use of the stroller.
Installing the Rear Wheels
Please use the following component sequence that indicates how all the parts for the rear wheel
assembly are installed.
• Turn stroller upside down, on a clean surface, so that it rests on the handlebar.
• Insert one end of the rear wheel axle through a rear axle hole in the plastic bracket under the
stand-on platform.
Figure 2
Figure 3
Page 3
Axle
Small
Washer
Wheel
Large
Washer
Spring
Washer
Snap
Pin
Hub
Cap
1
2
3
4
5
6
7
8
Large
Washer
