JOOLCA HOTTAP – MODEL JCA11001 USER GUIDE
7
This appliance can be used with a water input source that
provides at least 45kPa of pressure. This guide will use a mains
pressure (i.e. garden tap) as the water input source.
For use with water input sources, such as the FLOTAP low
voltage pump, please consult the pump instruction manual or
call customer service on 1300 669 500.
1.
Find a suitable, sturdy, non-combustible vertical surface
to hang the appliance on via the mounting tabs. The
surface should be at least 500mm clear from the sides
and 1000mm from the top of all combustible surfaces,
fabrics, flammable materials and people.
2.
Connect the flexible gas hose to the ‘gas inlet’. Tighten
the connection with a spanner, taking care not to over
tighten as doing so may damage the assembly.
3.
Connect the gas regulator to the POL propane gas
cylinder. Hand-tighten the connection in an anti-
clockwise direction.
4.
Turn the gas cylinder on, ‘Open’, in an anticlockwise
direction one full turn. Check the connection for leaks
by coating orifices with soapy water.
DO NOT use a
flame
. If bubbles occur or a leak is detected, turn the
cylinder valve off, ‘Close’, retighten all connections and
retest.
5.
Once it has been determined that there are no leaks
present, the appliance is ready to use. Leave the gas
cylinder off.
Note:
The gas cylinder must be positioned away and to
the side of the appliance. It must never be directly aside,
below or above the appliance.
1
2
3
4
Gas Connection
