Installation
Pull out the ball container vertically (picture 1). Aim to the position locating slot,
and then position the ball container (picture 2). Tighten the container lock on
both sides (picture 3). Tighten the poke bar inside the ball container (picture 4).
Location
Place the robot in the central area close to the edge of the table. Install the
support for the remote control on the edge of player’s side and insert the
control box into the support (picture 6).
Adjustment of speed
The speed of the ball is adjusted with the knobs on the remote control. There
are several stages of adjustment. The remote control saves the speed and ball
frequency last used before switching off.
Ways of serving balls
The ball can be served directly or indirectly. Direct balls have a higher speed
and more rotation than indirect balls and can be adjusted with the loop
adjustment knob.
Adjustment of loop
Loop is adjusted with the loop adjustment knob. The
loop also depends on where the robot is placed i.e.
distance and height from the table.
Adjustment of angle
The angle of the balls served is adjusted with the
angle adjustment knob. The angle increases when
the balls rotate clockwise and decreases when
balls rotate anti-clockwise.
Selection of rotation
Loosen the spin locking knob for adjustment of
rotation. Turn the handle to the required position
scale on the motor. Select the desired position of
rotation and fasten the spin locking knob. The
motor can be swung around for 180°.
Security advice
Instruction should be given when machine is used by children. Do not use
outside on windy or rainy days. When the robot is operating, please don’t touch
the friction wheel and poke bar and keep away from the shooting head. If you
find something abnormal, such as smoke coming from the machine please stop
the robot and unplug it immediately. Repair or service must be performed by a
qualified person. After use switch off and unplug the robot.
Subject to change without notice.
