3. Apply the parking brake.
Note: For FR 2312 MA, the parking brake is on the
left side. For FR 2312 M, the parking brake is on the
right side.
4. For FR 2312 M, put the gearshift lever in the neutral
position (N).
N
5. Put the throttle control in start position.
a) If the engine is cold, put the throttle control in
position (C), choke position.
A
B
C
b) If the engine is warm, put the throttle control
between positions (A) and (B).
A
B
C
6. Turn the ignition key to the start position.
7. When the engine starts, immediately release the
ignition key to neutral position.
Note: Do not run the starter for more than 5 seconds
at a time. If the engine does not start, wait 15
seconds before you try again. Then if the engine
does not start, wait 1 minute before you try again.
8. Let the engine run at half throttle (B) for 3-5 minutes
before you apply heavy load.
9. Set the engine speed with the throttle control.
Note: To engage the blades when the engine is at full
speed causes strain on the drive belts. Do not apply full
throttle until the cutting deck has been lowered to the
mow position.
To operate the product, FR 2312 MA
1. Select cutting height (1–5) with the cutting height
lever.
2. Start the engine.
14
512 - 001 - 26.01.2018
