Jonsered BC2043, Руководство оператора

Страница: 12 / 32

12 –
English
ASSEMBLY
9 Lap and fix the stop switch wires and connectors with
clamp (I).
10 Refit the air filter cover.
Assembling the cutting equipment
Fitting the cord cutter and guard extension
to the trimmer guard
• Attach the cord cutter to the guard extension with screw
and washer as shown.
• Fit the guard extension to the trimmer guard as shown.
Fitting a blade guard, grass blade and
grass cutter
• Fit the guard (A) to the gear housing using the support
plate (M) and two screws (L).
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Place the blade (D), support cup (E) and support flange
(F) on the output shaft.
• Fit the nut (G). The nut must be tightened to a torque of
35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool
kit. Hold the shaft of the spanner as close to the blade
guard as possible. To tighten the nut, turn the spanner in
the opposite direction to the direction of rotation (Caution!
left-hand thread).
!
WARNING! When fitting the cutting
attachment it is extremely important that the
raised section on the drive disc/support
flange engages correctly in the centre hole
of the cutting attachment. If the cutting
attachment is fitted incorrectly it can result
in serious and/or fatal personal injury.
!
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
IMPORTANT! If a saw blade or grass blade are to be used
the machine must be equipped with the correct handlebar,
blade guard and harness.
I
M
L
A
C
B
G
E
D
B
C
F