SPREADER PARTS AND HARDWARE
KEY
DESCRIPTION
QUANTITY
A
Handle with Broadcast Adjuster(Hardware Included)
1
B
Spreader Assembly
1
Figure 1
Note:
Hardware included
with spreader handle.
Carriage
Bolt
Nut
Protective
Cover
Spreader Assembly
1. (See Figure 1)
Remove protective packing
materials from handle and
spreader assembly.
2. Remove pre-installed hardware
from spreader handle.
3. Raise the top of the handle
with adjuster to the position,
align holes in handle with
spreader assembly and secure
with carriage bolts and
nuts provided.
4. Place protective caps over
exposed threads on bolt.
Calibration Adjustments
1. (See Figure 2) Place spreader on side with control lever
facing upward.
2. Set spreader to number 5 and hold control lever against
handle.The shut off plates inside the hopper should be
half open.
3. To adjust alignment, turn the calibration nut until flush with
tension arm.
Calibration nut should fit snug against tension arm.
Spreader Settings
(see back page for product spreader settings)
1. Always check spreader rate settings before you start. Some
products applied at a rate above the manufacturers
recommendations can cause damage to your lawn.
2. To manually calculate the proper setting number, pre-weigh the amount of product recommended
by the manufacturer for 1,000 sq.ft. Put the pre-weighed product in the hopper. Select a low
setting on the controller; begin spreading the material on a pre-marked 1,000 sq. ft. area.
After covering the pre-marked area, estimate the amount of material remaining and adjust the
controller setting accordingly. The proper setting is achieved when the hopper runs out at the
end of the area to be covered.
Controller Use
1. (See Figure 3) Using adjustment knob, align desired setting with pointer inside window.
Spreader setting 1.... Lowest flow rate
Spreader setting 10.... highest flow rate
2. While pushing the spreader forward, pull the control
level back to the open position.
CAUTION:
Some fertilizers may burn your lawn if over applied. Do not
operate the spreader backwards or stop forward motion of
spreader while control lever is in the open position.
3. To stop, release the control lever while still pushing the
spreader forward.
Application Ti ps
1. Walk at a steady brisk walking speed, approximately 4 feet per second.
2. Do not leave spreader open while making turns.
3. Partially overlap each “pass”to avoid missing areas of your lawn. Usually an overlap of
approximately 1 foot will eliminate this problem.
For best results do not apply on a windy day.
Maintenance
1. Remove unused product from the hopper after use and put in original container sealed tightly.
2. Clean the spreader thoroughly with soap and water after each use. Fertilizer or other material left
in the hopper, control valve, spinner plate and other components cause poor spreader performance.
3. Allow spreader to dry before storage and store in a clean, dry place. Spray lubricant on moving
parts after spreader dries. Tighten bolts and inflate tires as needed after each use.
4. Transmission is factory lubricated and requires no maintenance.
Figure 3
WARNING
This product can expose you to chemicals including lead and lead compounds which are known
to the State of California to cause cancer and birth defects or other reproductive harm. For more
information, go to www.P65Warnings.ca.gov
Figure 2
