1. Installation
Please turn off the euro rack prior to the wiring! On the backside of the T-
Rackonizer module you can find these connections:
1.1. Installation in the eurorack
Please connect the supplied ribbon cable to the eurorack system bus rails as
shown on the pictures. The module needs +/-12 Volts at a supply current of
maximum 130mA on +12V and about 70mA on -12 Volts. The optional 5
Volts and the CV/Gate on the A-100 Doepfer bus are both not wired inside
the Jomox module and not needed.
Other 10 pin systems may be used as well if only the lower part of the 16
pin connector is connected.
Please pay attention for the position of the voltages and the ground pins!
