12
Preparation for operation/Operation
Batteries
Safety measures when working with batteries:
Battery connection diagram
Charging procedure (traction block batteries with integrated charging
unit)
After completing the charging and with immediate use:
Charging procedure (traction block batteries with external charging unit)
Attaching tools
Check:
• that the tools are not below the red marking and that the bristle length is not
less than 1 cm.
• the pad for wear before using.
Attach squeegee
Filling water
Caution:
Only maintenence-free gel traction block batteries may be used!
Please follow the instructions of use for your battery charger!
• Protective goggles must be worn when working on the
batteries.
• Do not subject batteries to an open flame or heat as there is a
danger of explosion from the electolytic gas present in the
cells!
• No smoking!
• Danger of chemical burns!
Caution:
The battery must always be clean and dry. Do not place any
metallic objects on the battery.
The integrated charging unit is only suitable for maintenance-free
gel traction block batteries.
Caution:
Batteries may only be installed or dismounted by customer
service personnel or specialists approved by JohnsonDiversey
who are aware of all the safety regulations that apply here!
• Check that the machine has been switched off with the keyswitch.
• Disconnect the battery from the machine using the battery disconnection
socket.
• Plug the power supply cord into the mains socket.
• The yellow indicator lights up permanently until
approx. 90% of the battery capacity has been
reached. After that, the indicator blinks until the
battery is fully charged.
• When the charging process is complete, the
green indicator lights up.
• Leave the power supply cord connected to the mains until you use the
machine again. The on-board charger unit automatically monitors and
charges the batteries. The energy consumption in the mode is limited to a
few milliwatts.
• If a fault occurs during the charging process as
the result of a defect in the charging unit, an
interruption of a cable or a defective battery cell,
the red indicator will light up.
12V
24V
12V
75 A
• Unplug the connection to the mains socket.
• Connect the battery to the machine with the battery disconnection socket.
• Check that the machine has been switched off with the keyswitch.
• Disconnect the battery from the machine using the battery disconnection
socket.
• Connect the battery disconnection socket to the external battery charging
unit (pay attention to the voltage from the mains supply socket).
Caution:
Follow the instructions of use for your battery charger!
• Switch the machine off using the keyswitch and remove the key.
Working with worn out, damaged and or wrong tools, could result
in possible damage to floors or their protective layers.
• Position the tool below the brush unit.
• Switch on the keyswitch.
• Unlatch the foot lever and slowly lower the tool.
• Briefly pull the brush drive bar.
By doing this the tool will be centered and coupled.
• Switch the machine off.
• Raise the squeegee and loosen the fixing
screws on the squeegee.
The squeegee support wheel must be in the
direction of movement.
• Assemble the squeegee and tighten the fixation
knobs.
• Attach the suction hose to the squeegee.
Caution:
Maximum permissible water temperature 60 °C/140 °F.
• Switch the machine off.
• Lift the tank lid.
• Fill water into the solution tank.
Maximum permissible filling level (Page 11).
max.60
˚
C
max.140
˚
F
