minnkotamotors.com | 31
©2018 Johnson Outdoors Marine Electronics, Inc.
FEATURE OvERvIEW AND CONNECTING THE CABLES
Four Pin
Connector
Universal Sonar
Cable from
Control Head
NOTICE:
Your fish finder should be turned
off until this procedure is complete.
NOTICE:
If the cable length does not reach the desired
fish finder installation location, a 14.5’ extension cable is
available (MKR-US2-11) (sold separately).
a. Place the motor in the deployed position.
b. Locate the Universal Sonar, if equipped, at the base
of the Mount.
c. Locate the Universal Sonar four pin connector at
the end of Universal Sonar Extension Cable. The
connector is black with a stainless steel threaded
locking collar.
1
The connector for Universal Sonar exits the trolling motor below the Control Head and consists of a 4 pin plug. An adapter cable (MKR-
US2-11) that is sold separately is required for all installations. For a current list of compatible fish finders and the correct adapter cable,
or more information on Universal Sonar, please visit
NOTICE:
Universal Sonar does not support imaging screens that require higher frequencies such as 455 kHz or 800 kHz (Down
Imaging, Side Imaging, etc.). Down Imaging (DI) specific units are not compatible with Universal Sonar. See compatibility chart
for a list of compatible fish finders at
.
Control
Head
Coil Cord
Mount
Built-in MEGA
Down Imaging or
Universal Sonar
i-Pilot Link
i-Pilot
Link
The Universal Sonar Cables are shielded to minimize interference. To protect this shielding the cables should not be pulled tight against
sharp angles or hard objects. If using cable ties, do not over-tighten. Any excess cable should be bundled in a loose loop of no less than
4” in diameter. In certain situations, air bubbles may adhere to the surface of the Universal Sonar transducer, and effect the performance.
If this happens simply wipe the surface of the transducer with your finger.
