22 | minnkotamotors.com
©2018 Johnson Outdoors Marine Electronics, Inc.
ORIENTATE THE PEDAL CONTROL SLEEvE ASSEMBLY FOR A STARBOARD MOUNT
Wrap Drum
Cover
Wires
Steering
Module
Screws
Cable
Tension
Screw
Toe End of
Foot Pedal
Cable
Anchor
Wrap Drum
Cover
Steering Motor
Connection Wire
n. Re-tighten the two screws that fasten the Cable
Anchor to the top of the Steering Module using a #2
Phillips screwdriver. Tighten to 25 in-lbs.
o. Using a #3 Phillips screwdriver, tighten the Cable
Tension Screw located at the base of the Toe End of
the Foot Pedal to 10 - 12 in-lbs until the Steering
Cables are under tension or re-tighten the same
number of turns as was used in step 4f.
q. Place the Wrap Drum Cover down on top of the Cable
Anchor and align the screw holes on it with the screw
holes on the Cable Anchor. Make sure the Wrap
Drum Cover is nested securely on top of the Steering
Module and that the wires pass out the top of the
Wrap Drum Housing. Secure the Wrap Drum Housing
in place with the two screws that were originally
removed using a #1 Phillips screwdriver. Tighten to
6 in-lbs.
Cable
Anchor
Screws
Steering
Module
CAUTION
Do not over tighten the Cable Tension Screw, as excessive
tension will cause damage to the unit.
9
10
11
10p
10q
CAUTION
Take care not to pinch the Steering Motor Connection Wire
while the Wrap Drum is set into place.
p. Reconfirm that the Steering Cables are tight and
then carefully thread the Steering Motor Connection
Wire through the top of the Wrap Drum Cover. The
male plug comes from the Cable Anchor through
the opening at the bottom of the Wrap Drum Cover.
The wire with the female plug that runs out the top
of the Cable Gear should also be pulled through the
opening at the bottom of the Wrap Drum Cover.
