UPSPNL550-0 Panel Installation Instructions
4
7.
Place the cover on the enclosure. The unit is ready for charging and is able to function as designed after the
proper amount of charging time.
IMPORTANT:
See the enclosed CyberPower User’s Manual for the proper charging time, discharge time, load
characteristics, and all other relevant information for the UPS.
Piping
When installing, follow the standard electrical practices per local codes. Make the necessary enclosure conduit
connections using standard tools. You may need to make the conduit entry hole for the field. Do not interfere with
the vents on the side of the unit when making an opening. Ensure that no loose metal filings rest on the internal
components in the enclosure. Remove any containments and clean the inside of the enclosure as needed.
Setup and Adjustments
To set up the panel and UPS, follow the CyberPower User’s Manual, which is included with the enclosure.
Operation
To operate the panel and UPS, follow the CyberPower User’s Manual, which is included with the enclosure.
Repair Information
If the UPSPNL550-0 fails to operate within its specifications, replace the defective component. For a replacement,
contact the nearest Johnson Controls® representative.
Replacing the UPS
To replace the CyberPower UPS, complete the following steps while wearing the appropriate personal protective
equipment:
1.
Place the main breaker that is supplying power to the panel in the Off position.
2.
Remove the panel cover.
3.
Place the breaker inside the panel in the Off position.
4.
Turn off the CyberPower UPS by pressing its power button for approximately two seconds. Release it after you
hear two short beeps.
5.
Unplug the CyberPower UPS from the AC power outlet inside the panel.
Note:
Make a note of the electrical connections.
6.
Remove the existing CyberPower UPS unit.
7.
Place the new UPS in the panel and install the necessary electrical connections.
8.
While wearing the appropriate personal protective equipment, switch the main supply breaker to the On
position.
9.
Turn on the breaker that is inside the panel.
10. Press the power button on the CyberPower UPS for approximately two seconds and release it after you hear a
short beep. A green light signifies that power is on.
11. Reinstall the panel cover.
