background image

T6634-TA10

҈

TE20

҈

TF20-9JS0 Series Fan Coil Thermostat (ON/OFF) - Installation Instructions 

T6634-TA10

҈

TE20

҈

TF20-9JS0

亨⏄橻㣧䢅䵎㿖㕔⠕

 (

キ⌠⤸

) -

ⴶ婲嶡㞻

601V-B01A-NB Rev 2-Issue Date 09 2012

4

捺嬮

 T6000

Ⴜளၫ૿ධ੡ቂᏮ኷ღݢᅼࠞ঩ധ࣏૿፟໪ቂȃܬ

T6000

Ⴜளၫ૿ධݲ੅

Ꭷ፜໘ௌডࢽጊ໢૰೙ঐܷ፛เ኎ພࣷˈاٛཿ໘ঽඝྋിֻཿ।ȃዓৠኁ߷
܈໚ˈ๜٢໪ቂ৭૿ঽ֫੸Ⴜ࿾Ȃݢᅼ֦॓૑࣋݃ˈ኷՗ᎧႼ࿾፩ȃହৠූۨ
ၫޡݲ੅Ꭷ፜ܿ঩೙໘٢ञ໘ᄌ໢֦ܿ॓ȃ

 

؜ᇋնၫ૿ධᎧ኷ੌ௷Ȃٰ໛ড቏໛නۃȃ໛නঐཿ।ၫ૿ධȃ

 

؜ᇋն࠙๠෇࡜ܿ

PCB

֊ᇧڵˈ۰෇࡜፩ն࠙๠ܿ

PCB

֊ّᄛᇧڵਖ؜኶ჴ቏፣

֦࠵ႚȃ

 

໪ྈ቏ਾღ࠲ठ࣭য়Ȃݓฏञܬݓܿࣙށȃ؜ᇋ٫ࣰ

T6000

Ⴜளၫ૿ධݢ௚

๒஢ȃ

 

  

崓◷

 

኷੣ᄵݢධਾღ໢ฬ֦ݢኑި૑ȃ኷ܕݢ໢ஏਾࢌؠ਋૰೙ሞඩݢদˈ۰ߑܷ፛
เ኎།ພ່ፚཏ၁ȃ

 

ݢদ၌ნ

 

ՙጐ࣭য়Ȃݓฏञܬݓܿࣙށࢍၫ૿ධਾݓȃਾݓ໘ᄌ૰೙ܷ፛ݢদञเ኎ພ၁

 

່ፚཏ၁ȃ

 

ݢদ၌ნञا႘ཿ।

 

኷ၫ૿ධ࿳ݢ෇նၝ໪ቂܿღဂ֦॓औˈ໪ፇુኒȃใटᇜࢋၝ໪ቂܿღဂၝ־

 

ુኒञ֦॓૰೙ܷ፛اٛཿ।ˈݢদञเ኎ພ၁່ፚཏ၁ȃ

 

  

㺕㊼

኷ྈᇵܿਾღၝ৹يऔፇ෇ˈ؜ᇋࢍႼ࿾࿳ݢȃޥ௸ড؜ጸฬܿਾღ૰೙ܷ፛ົֻ

ሿઌᄹܿཿ।ȃ

IMPORTANT

ǖ

  Use this T6000 Series Line Voltage Fan Coil Thermostat only as an operating 

control. Where failure of malfunction of the T6000 Series Thermostat could 
lead to personal injury or property damage to the controlled equipment or other 
property, additional precautions must be designed into the system. Incorporate 
and maintain other devices such as supervisory or alarm systems or safety or 
limit controls intended to warn of, or protect against, failure or malfunction of the 
T6000 Series Thermostat.

  Do not install this thermostat in condensing, wet, or damp environments. Moisture 

may cause damage to the thermostat.

  Do not remove PCB from the enclosure cover. Removing the PCB from the 

enclosure cover voids the product warranty. 

  Make all wiring connections in accordance with local, nation, and regional 

regulations. Do not exceed the T6000 Series thermostat's electrical ratings.

  

WARNING: 

  Disconnect power supply before making electrical connections. Contact with 

components carrying hazardous voltages can cause electrical shock and may result 
in severe personal injury or death.

  Risk of Electrical Shock

 

Ground the thermostat according to local, national, and regional regulations. 
Failure to ground the thermostat may result in electrical shock and severe personal 
injury and death.

    Risk of Electrical Shock and Property Damage

 

Insulate and secure each unused wire lead before applying power to the 
thermostat. Failure to insulate and secure each unused wire lead may result 
property damage, electrical shock, and severe personal injury or death. 

  

CAUTION: 

Do not apply power to the system before checking all wiring connections. Short 
circuited or improperly connected wires may result in permanent damage to the 
equipment.

Содержание T6000 Series

Страница 1: ...n read the display and adjust the setpoint easily Situate the thermostat where the temperature is representative of the general room conditions Avoid installing the T6000 near cold or warm air drafts radiant heat on an outside wall or in direct sunlight Mounting Mount the T6000 Series thermostat to a 75x75x35mm standard electrical wallbox See Figure 3 Follow the instruction in removing the base an...

Страница 2: ...n cycles for cooling and heating control This is to make sure that all control devices are functioning correctly If the device is not working properly and the wiring is correct the thermostat should be replaced by contacting your nearest Johnson Controls Representative Setup and Adjustments Turn ON OFF the T6000 Thermostat by pressing the On Off button After turning on the T6000 Thermostat ambient...

Страница 3: ...Johnson Controls ۃ Ⴜȃ ܬ Ⴜ ۃ ४ٛ ܿ ृˈขངಖိ ؠ වড د װ ຢሠ ܿ ᄲ ᄲखȃ रຍ ຕ ข ૣد ٛ ངಖ ȃ Setting Parameter To enable the operation mode press the M and ɘ until icon appears When the thermostat is turned off Press M to switch functions between press or ɘ to adjust the parameter See Table 2 for the functions Calibration Do not calibrate the T6000 Series thermostat in the field Troubleshooting After a power outa...

Страница 4: ...ainst failure or malfunction of the T6000 Series Thermostat Do not install this thermostat in condensing wet or damp environments Moisture may cause damage to the thermostat Do not remove PCB from the enclosure cover Removing the PCB from the enclosure cover voids the product warranty Make all wiring connections in accordance with local nation and regional regulations Do not exceed the T6000 Serie...

Отзывы: