Enrolling the device
1. Refer to the control panel installation manual for the complete set of enrollment instructions
and testing procedures.
2. From the
Installation
menu, enter the
Device enrollment
menu and select the option to add
a new device.
3. Remove the battery pull-tab to power on the device and begin the auto-enrollment process.
If the battery pull-tab is not available or if the device does not automatically enroll, open the
device cover to trigger the enrollment.
4. If requested, enter the PIN code printed on the device label.
5. To manually enroll the device:
a.
Scan the QR Code on the device box, using the IQ4 camera if available, or see step b.
b.
Manually enter the device ID, printed on the product label, in the format 103-XXXX.
Note:
If the device has been powered up for more than 2 hours it will be identified by
the system only after the device has been reset.
The MC-303 PG+ is enrolled with device ID 103-XXXX. In fall back mode it enrolls as MC-303
PG2 with device ID 109-XXXX.
6. Select the desired zone.
7. Configure any device parameters that are required.
8. Mount and test the device. See
for information on testing the device.
Configuring the device parameters
1. Enter the
DEVICE SETTINGS
menu and select the required configuration as described in the
following table:
Table 1: Configuration options
Option
Action
Alarm LED
Define whether the alarm LED indication will be activated.
Optional settings:
LED ON
(default) and
LED OFF
.
Mounting the device using tape
1. Peel the release liners off the two strips of double-sided adhesive tape and attach the tape to
the back of the device and the magnet. See the following figure.
Figure 2: Double-sided adhesive tape placement on the device and magnet
MC-303 PG+ Vanishing Door/Window Magnetic Contact Installation Guide
2
D-308437 MC-303 PG+ Rev. 0
