FX80 Supervisory Controller Installation
Instructions
Applications
This document describes how to mount and wire the following:
• DIN-mount, 24 VAC/DC powered FX80 controller
• Wall-mount, Class 2 universal AC power adapter supplying 24 VAC
Note:
The FX80 controller requires, at a minimum, FX Supervisory Release 14.1. A maximum
of four total option card modules are supported. Separate limits may exist in the controller’s
license to further limit functionality.
Figure 1: FX80 Controller
North American Emissions Compliance
United States
This equipment has been tested and found to comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when this equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area may cause harmful
interference, in which case the users will be required to correct the interference at their own
expense.
Part No. 24-10143-861 Rev. A
2019-03-22
(barcode for factory use only)
FX-SC8BASE-0, FX-SC8BASE-700
*2410143861A*
