Risk of Property Damage.
Do not apply power to the
system before checking all wiring connections. Short
circuited or improperly connected wires may result in
permanent damage to the equipment.
MISE EN GARDE: Risque dégâts matériels.
Ne pas
mettre le système sous tension avant d'avoir vérifié tous
les raccords de câblage. Des fils formant un court-circuit
ou connectés de façon incorrecte risquent
d'endommager irrémédiablement l'équipement.
If desired, you can use the wall mount power adapter in
your office to initially commission the FX30E/FX60E, and
then install the DIN rail mount power supply at the project
site.
Important:
Do not connect both the LP-FXPMUS and
LP-FXPM24 supplies at the same time, or
equipment damage may result.
Wall Mount Power Module
Three models of wall power modules are available: United
States (U.S.), European Union (EU), and United Kingdom
(U.K.). All are self-contained, isolated switching power
supplies designed to plug into a standard building power
receptacle for appropriate voltage. To supply power to
the FX30E/FX60E, you simply plug the barrel connector
plug from the power module into the barrel power
connector on the FX30E/FX60E base unit.
Important:
Do not plug the barrel connector plug from
the power module into the FX30E/FX60E
until all other mounting and wiring is
completed.
Wiring LP-FXPM24-0 Power Module
The LP-FXPM24-0 module lets you power the
FX30E/FX60E (and, if installed, the NDIO16 modules)
from a dedicated, Class 2, 24 VAC transformer, or from
a 24 VDC power supply. If installing NDIO16 modules,
install the power module as the last (end) module in the
chain. See
Figure 5
.
Important:
If powering from a 24 VAC transformer, do
not power any other equipment with it.
Otherwise, conducted noise problems may
result. Also, do not ground either side of the
transformer’s secondary.
Located at the bottom of the power module are a
2-position power connector and an earth ground spade
lug. Connect the supplied earth ground wire to a nearby
earth ground point. Unplug the power connector plug
from the module and make connections to it.
Risk of Property Damage.
Do not apply power to the
system before checking all wiring connections. Short
circuited or improperly connected wires may result in
permanent damage to the equipment.
MISE EN GARDE: Risque dégâts matériels.
Ne pas
mettre le système sous tension avant d'avoir vérifié tous
les raccords de câblage. Des fils formant un court-circuit
ou connectés de façon incorrecte risquent
d'endommager irrémédiablement l'équipement.
Power consumption depends on installed accessories
and option cards, and may vary from:
•
FX30E/FX60E with power module alone:
approximately 7.5 VA (AC) or 7.5 W (DC)
•
FX30E/FX60E with power module and 4 NDIO
modules, plus option cards: up to 20 VA (AC) or 20
W (DC)
12
FX30E/FX60E Supervisory Controllers Installation Instructions
