Johnson Controls CK722, Руководство пользователя, Страница: 26 / 32

Installation CK722 Network Utility Tool
2-10 24-10239-30 Rev. D
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2016 Johnson Controls, Inc.
If you have not configured any CK722 controllers, the top section of the
screen (Target section) appears blank. To configure CK722 controllers, see
“Adding CK722 Targets” on page
2-7.
2. From the menu bar, select Options>Automatically Scroll Log Window .
This feature allows you to see the most up-to-date log messages as they are
created.
N
OTE
To save the contents of the Network Utility Tool log to a .txt file at any time
in the process, select
File>Save Diagnostic Log from the menu bar.
3. Make sure the Status column entry for the CK722 is set to Enabled .
If the Status entry is not Enabled, double-click on the Status column entry
for the CK722 you want to update. The Edit update target screen appears. In
the Status drop-down box, select
Enabled and click Ok .
N
OTE
Whenever you reopen the Edit update target screen from the Network
Utility Tool main screen, the update type of the selected CK722 target
reverts to
Quick . Change to Extended before clicking Ok .
4. Use a paper clip to press the SYSTEM RE-BOOT switch or cycle power to
the CK722 controller.
The CK722 SYSTEM RE-BOOT switch is inside a round, unmarked hole
on the face of the controller, just below the battery compartment.
SYSTEM RE-BOOT Switch Opening
Figure 2-2: Location of CK722 SYSTEM RE-BOOT Switch