Johnson Controls CCXL01, Инструкция по эксплуатации

Страница: 6 / 24

iv TC-19001
● Use an exclusive power supply at the controller’s rated voltage.
● Be sure to install circuit breakers (ground fault interrupter, isolating switch, molded case circuit breaker, and
so forth) with the speci
fi ed capacity. Ensure that the wiring terminals are tightened securely to recommended
torque speci fi cations.
● Clamp electrical wires securely with a cord clamp after all wiring is connected to the terminal block.
In addition, run wires securely through the wiring access channel.
● When installing the power lines, do not apply tension to the cables. Secure the suspended cables at regular
intervals, but not too tightly.
● Make sure that the terminals do not come into contact with the surface of the electrical box.
If the terminals are too close to the surface, it may lead to failures at the terminal connection.
● Do not clean with, or pour water into, the controller as it could cause electric shock and/or damage the unit.
Do not use strong detergent such as a solvent. Clean with a soft cloth.
● Check that the ground wire is securely connected. Do not connect ground wiring to gas piping, water piping,
lighting conductor, or telephone ground wiring.
● If there are frequent occurrences with blown fuses or fl ipped circuit breakers, shut down the system
immediately and contact your service contractor.