Johnson & Johnson Vision ACUVUE 2, Инструкция по эксплуатации

Страница: 8 / 33

14 15
Placing the lens on the eye
1. Remember to start with your
right eye. Once the lens has
been examined and you are
sure it is not inside out, place
it on the tip of your forefinger.
2. Place the middle finger of
the same hand close to your
lower eyelashes and pull
down the lower lid.
3. Use the forefinger or middle
finger of the other hand to lift
the upper lid and place the
lens on the eye.
4. Gently release both lids and blink.
5. Repeat these steps for the left lens.
There are other methods of lens placement. If the above method
alternative.
Inserting your lenses
To avoid mix-ups, develop the habit of always inserting the first
lens in your right eye.
Before inserting the lens, check to see that it is a single, moist, clean
lens that is free of any nicks or tears. If it appears damaged, throw it
away and use the next lens.
Check that the lens has not turned inside out.
Place the lens on the tip of your forefinger and check its profile.
The lens should assume a natural, curved, bowl-like shape.
If the lens edges tend to point outward, the lens is inside out.
Another method is to gently squeeze the lens between the thumb
and forefinger. The edges should turn inward. If the lens is inside
out, the edges will turn slightly outward.
Or
Place the lens on the tip of your index finger and, looking up at
the lens, locate the numbers 123. 1-2-3 indicates correct orientation
while a reverse of 1-2-3 indicates the lens is inside out. If the lens
is inside out (reverse 1-2-3), invert the lens and locate the numbers
again to confirm correct lens orientation.
Note that the 1-2-3 mark is not present on ACUVUE® Brand Contact
Lenses for ASTIGMATISM and ACUVUE OASYS® Brand Contact
Lenses for PRESBYOPIA with HYDRACLEAR® PLUS.
Note:
If you need to rinse the lens before you insert it into your eye, use
only fresh, sterile rinsing solution, as recommended by your Eye
Care Professional.
NEVER USE TAP WATER.
✓
Correct
✗
Incorrect