John Lewis JLFSMFC 601, Инструкция по эксплуатации

Страница: 12 / 24

Conversion from natural gas to LPG
Unscrew the adjustment screw Z to increa-
se the flow, or tighten it to reduce the flow.
The adjustment is correct when the low
flame measures approximately 3 or 4 mm.
When changing quickly from maximum to
minimum flow and vice versa make sure
that the flame does not go out.
It is important to note that this model is designed
for use with natural gas but can be converted for
use with butane or propane gas (conversion kit
included) providing the correct injectors are fitted.
The gas rate is adjusted to suit.
Proceed as follows:
• Remove the pan supports;
• Remove the burners and burner caps (Fig. A);
• Take out the injector (Fig. B) and replace it with
one suitable for the new type of gas (see „Gene-
ral injectors table‰);
• Replace the gas label (on the rear of the ap-
pliance) with the new one provided with the
injectors kit;
• Refit all parts by following the disassembly
instructions in reverse order and taking care to
position the burner cap correctly on the burner.
Minimum flow of valved cooking
hob taps
• Switch on the burner and turn the control knob
towards the minimum flow position ;
• Remove the knob;
• Using a screwdriver, adjust the internal screw Z
until the correct low flame is obtained;
• Refit the knob.
Minimum flow of non-valved
cooking hob taps
• Switch on the burner and turn the control knob
towards the minimum flow position ;
• Remove the knob;
• Insert a small screwdriver into the rod of the tap
and adjust the internal screw Z until the correct
low flame is obtained;
• Refit the knob.
12
Connecting to LPG
Use a pressure regulator and connect to the
cylinder in compliance with the guidelines set out
in standards regulations in force.
L.P.G. cookers MUST NOT be installed
below ground level i.e. in a basement or
aboard any boat, yacht or other vessel.
General injectors table
TYPE OF GAS mBar INJECTOR NO. BURNERS
POSITION TYPE
POWER Watts MAX.
CONSUMPTION
INJECTOR BY-PASS MAX MIN
NATURAL
GAS
G20 (E) 20
127 39 GAP RAPID 3000 500 286 l/h
97 29 GAP SEMI-RAPID 1750 350 167 l/h
77 27 GAP SIMMER 1000 290 95 l/h
136 65 GAP TRIPLE RING 3900 1500 371 l/h
LPG
BUTANE
PROPANE
G30/G31
28-30/37
85 39 GAP RAPID 3000 500 219 g/h
65 29 GAP SEMI-RAPID 1750 350 128 g/h
50 27 GAP SIMMER 1000 290 73 g/h
100 65GAP TRIPLE RING 3900 1500 284 g/h