384W — Page 9
10.
Attach each outer slide section (ZA) removed earlier to each side of the drawer. Align the two
outer holes on the slide with the pre-drilled holes on the Drawer Sides (H) and use Screw (V)
to hold slide in place. Make sure the closed end of the outer slide section is toward the Drawer
Face (K). Secure the outer slide section with a third Screw (V) in one of the middle holes. See
FIGURE 10A.
Square the drawer by measuring from left front to right rear and from right front to left rear. The
measurements should be equal. If one is longer, hold the drawer by the corners on the longest
line and squeeze them together until square. See FIGURE 10B.
Attach two Knobs (ZB) to the Drawer Face (K) using two 1½” Machine Screws (ZC). See
FIGURE 10C.
V
x 6
FIG. 10A
FIG. 10C
ZB
x 2
ZC
x 2
Closed end of slide
towards drawer face.
ZA
— Outer
Slide Section
FIG. 9
9.
Attach two Drawer Sides (H) to the Drawer End (I) with Screw (T) through the predrilled holes in
the sides. The grooves for the Drawer Bottom must line up. Slide the Drawer Bottom (J) into the
grooves. Attach the Drawer Face (K) to the Drawer Sides (H) using Screw (T). See FIGURE 9.
T
x 8
FIG. 10B
T
T
T
T
T
T
T
T
I
J
K
V
V
V
K
H
V
V
V
K
ZB
ZB
ZC
ZC
H
H
