Page 8 — 384W
FIG. 8
8.
Stand the unit upright. Remove the outer slide section from each Ball Bearing Slide (ZA). To do
so, fully extend the slide as shown, press the release lever and remove each outer section. See
FIGURE 8.
U
G
G
7.
To square the unit, lay it face down on a protected surface, measure from top left to bottom right
and from bottom left to top right
. Measurements should be equal. If the line
is
longer, tap bottom of Left Side Assembly (C) until measurements are equal. If line
is longer,
tap bottom of Right Side Assembly (E). See FIGURE 7A.
Connect the two Backs (G) together using the Plastic H-Channel (U). Make sure to connect the
edges that do not have pre-drilled holes. See FIGURES 7C & 7D.
Attach the Backs (G) to the unit using Screws (V). Make sure the bottom edge of the back is flush
with the bottom edge of bottom shelf and equal distance from the sides.
Tap Tack Glides (X) into the bottom of each back leg. Thread the Adjustable Glides (Y) onto the
Plastic Inserts (Z) and tap into the holes in the bottom of the front legs. See FIGURES 7B & 7D.
Z
Y
X
x 2
Y
x 2
Z
x 2
V
x 22
FIG. 7A
FIG. 7B
FIG. 7C
FIG. 7D
G
G
V
V
V
V
X
X
Y&Z
E
C
U
ZA
Outer Slide Section
ZA
Release Lever
Y&Z
