Gluing Hints
1.
We
strongly
recommend that you first lay out all the parts
and familiarize yourself with how they fit together before
assembling with glue. Glue will set up quickly and can cause
damage to the parts if you try to reposition any that have
been assembled incorrectly.
2.
Glue usually takes several hours to cure (or harden) but it will
sometimes set up, or grab, in several seconds. Therefore,
once you begin final assembly, be sure to proceed quickly
and diligently.
3.
We recommend that you use a good wood glue, such as
Elmer’s Wood Glue or White Glue, Titebond Wood Glue
or the equivalent; unless the instructions call for a special
type such as a slow drying epoxy glue. Carefully read the
glue manufacturer’s label and follow all instructions.
4.
Be sure the holes are clear of any dust so the glue will have a clean surface to
adhere to. Blowing in the holes before gluing is recommended,
but be sure to
protect your eyes.
5.
Avoid getting glue on surfaces that are finished!
Wet glue can be wiped off
with a damp cloth.
6.
Do not over glue!
It is important to apply an even coat inside all holes and slots.
Use a small dowel, Q-tip or pencil to spread glue evenly around the inside of the
holes. Because of the fit of the spindles or dowels in the holes, the spindle or
dowel pushes glue to the bottom of the hole. If too much glue is used, it will fill the
hole and not allow the spindle or dowel to go all the way in.
Basic
Equipment:
Rags
Paper towels
Q-tips
Drop cloth
10/05
1-800-653-3336
Outside U.S. or Canada: 541-687-0213
Fax: 541-687-2060 • Email: [email protected]
Mail: P.O. Box 2827 • Eugene, Oregon 97402, U.S.A.
Carefully read the glue manufacturer’s label and follow all instructions.
These are general hints. Refer to the instruction sheet for detailed
information on gluing your specific product.
Your unit may not need glue.
