9)
Apply glue to both sides of the notch in the Front Crown Moulding (O) and place moulding over front
edge of Bottom (BB) centered side to side with wide edge toward the Legs. Repeat for the Left Crown
Moulding (Q) making sure that the front mitered corner is flush against the Front Crown Moulding.
Install the Right Crown Moulding (P) in the same way.
FIG. 9B
10)
Turn the unit upright. Glue and attach the front Crown Moulding (O), Right Crown Moulding (P),
and Left Crown Moulding (Q), with the wider surface up, to the Top (A) in the same way as in
Step 9.
FIG. 10A
11)
Attach the upper, middle, and lower Minaret Hinges (ZB) to the facings using the upper hole in each
hinge for the predrilled hole in the facing. Use #5x5/8" Flat Head Screws (ZH). Insert a screw in the
lower elongated hole in each hinge.
Attach the Doors (F) to the upper and lower hinges using the outermost hole in the hinges for the
predrilled holes in the doors. There is no predrilled hole for the center hinge in the door. Insert a
screw in the elongated holes in the hinges. If doors need to be adjusted up or down, or side to
side, loosen the appropriate screws in the elongated holes. When door is aligned properly using
the elongated holes, retighten screws. A third screw may be inserted through the round hole in the
hinge into the door.
FIG. 11
FIG. 11B
FIG. 11A
FACING
DOOR (F)
A
O
P
Q
O
BB
P
Q
FIG. 9A
ZH
ZH
ZB
ZB
FIG. 9
FIG. 10
O
/
P
/
Q
O
/
P
/
Q
276KFDC — PAGE 7
