20
Programme the transposer
1. Press the TRANS. button.
2. Set the pitch using the - and + buttons.
3. Press the SET button.
The pitch change is stored in memory. When the organ is
switched on again, the programmed pitch will be active.
4.14 General
Crescendo
The General Crescendo pedal can be used to activate different
registrations step-by-step. These registrations start with very quiet
(pianissimo) to very loud (tutti).
Activate the General Crescendo pedal
When the General Crescendo pedal has not been enabled, the display
shows the message
Cresc: Off
.
1.
Press the CR button to enable the General Crescendo pedal. The
display indicates which step has been set.
Change the General Crescendo pedal
The by default set stop combinations of the crescendo steps can be
changed and saved in the memory.
Only step 0 cannot be changed.
1.
First press the CR button, then the MENU button.
2. Use the - and + buttons to select the step to be changed.
3. Set the required registration for the step.
4. Press the SET button.
5. If necessary, select another step to be changed.
6. Press the MENU button to switch off the programming mode.
7. Press the CR button to switch off the General Crescendo mode.