Johannus Rembrandt 377 AGO, Руководство пользователя

Страница: 21 / 36

21
Programming a capture memory location
1. Select the desired stops.
2. Use the - and + pistons to select a level (
1-100
) on the display.
3. Press the SET piston. Hold the piston down.
4. Push the desired memory location (1-8) in.
5. Release the SET piston.
Calling up a capture memory location
1. Use the - and + pistons to select the desired level (
1-32
) on the display.
2. Push the desired memory location (1-8) in. The active stops light up.
4.11.2 General Volume
The set volume can be read on the display (
Vol:..
).
1. Push the VOL piston in.
2. Use the - and + pistons to set the volume.
3. Press the SET piston to save the volume in the memory.
4.11.3 Transposer
The Transposer function shifts the pitch by half-tone increments (from -8 to
+8). The set pitch can be read on the display (
Trans:..
).
Changing the transposer
1. Push the TRANS piston in.
2. Use the - and + pistons to set the pitch.
The current setting of the capture memory location will be lost.
The volume can only be programmed when the VOL. piston is lit.
The volume change is in the memory. When the organ is switched
on again, the programmed volume will be active.
The pitch can only be programmed when the TRANS. piston is lit.
The pitch shift is not stored in memory. When the organ is switched
on again, the most recently programmed pitch will be active.