8
Maintenance
of Your Joerns Bed
Maintenance/Inspection Information:
Visually inspect the bed and accessories for broken welds or cracks,
and check for loose hardware on a monthly basis. If any broken welds or cracks are found, remove the bed
from service immediately and replace the affected part(s). Contact Sunrise Medical Technical Service for
assistance, if necessary. Any loose hardware should be tightened.
Servicing
of Your Joerns Bed
WARNING: POSSIBLE SHOCK HAZARD.
Unplug power cord from wall outlet before
performing any maintenance or service to the power box.
Motor and Control Box Information
Cord and Socket Identification (fig. 12)
A. Pendant/Staff Control
1. Not Used
2. Head Motor
3. Knee Motor
4. Emergency Battery Pack (sold separately)
Motor and Control Box Troubleshooting
Any loss of electrical function should be investigated with the following steps:
1. Make sure that all cords are plugged in, including pendant, staff control cords and AC Power.
2. There is a protection feature built into the motors and control box to prevent overheating. If the bed
was operating continuously, the motors may stop functioning for a short period of time to allow them
to cool. Full function will resume in less than 15 minutes.
3. Switch the pendant with a new one or from a bed that is functioning normally.
4. If these steps fail to resolve the problem, call the technical support hotline at the number shown on the
back cover of this manual.
To Remove Motor
Recommended Tools: Screwdriver, hammer, masking tape, zip ties
1. Identify motor to be replaced.
2. Tip bed on its side (to replace high/low motor).
4. Unplug motor cord.
5. The motor is held in place by two pins. Remove the lock ring on each pin with a screwdriver.
6. Slide pins out of holes. If necessary, use the hammer to tap out the pins.
7. Motors may now be replaced.
8. To reassemble bed, reverse the previous steps, making note of the following two important items:
· Assemble pin and locks as originally installed.
Figure 12
