Joe Due Z10, Руководство по эксплуатации

Страница: 9 / 37

9 / 37
OperatingManualZ10/Z20/Z30

Do not use with damaged cord or plug. If the machine is not working as it should, has been
dropped, damaged, left outdoors or dropped in water. Make sure it is repaired by a
qualified person.

Do not pull or carry by cord, use cord as handle, close a door on cord, or pull cord around
sharp edges or corners. Do not run the machine over cord. Keep cord away from heated
surfaces.

Do not unplug by pulling on cord. To unplug, grasp the plug. Not the cord.

Do not handle plug or machine with wet hands.

Regularly inspect cord and plug for damage. If cord is damaged, it must be replaced by a
qualified person in order to avoid hazard.

Turn off all controls before unplugging.

If using an extension cord make sure the cord rating is suitable for this machine.

Connect to a properly grounded outlet only. See grounding instructions.
9. Thermal protection
The dust extractor is equipped with a safety thermal protector to prevent motor from
overheating. Should thermal protector activate, turn off machine, unplug power cord and
check for full dust bag, vacuum hose clog or filter blockage. It may take up to 45 minutes for the
thermal protector to reset.
10. Grounding instructions
The dust extractor must be grounded. If a dust extractor malfunctions or breakdowns, grounding
provides a path of least resistance for electric current to reduce the risk of electric shock. The
dust extractor is equipped with a cord having an equipment-grounding conductor and
grounding plug. The plug must be inserted into an appropriate outlet that is properly installed
and grounded in accordance with all local codes and ordinances.
11. Service

When cleaning and servicing the machine, you must switch off the machine and remove
the plug from the outlet.

Don’t clean the machine with a high pressure cleaner. If necessary, do not direct at the
openings on the machine, especially the opening for cooling air.

Before moving the machine from the work area, the machine must be cleaned.

Proper personnel protective equipment must be used while replacing the pre-filter or the
HEPA filter. If possible, use a special suitable room.

All parts which are contaminated after service must be properly disposed of in plastic bags
according to all regulations.

If the machine has to be used for other purposes, it is extremely important that the machine
is cleaned, to avoid the spread of hazardous dust.

Do not puncture the HEPA filter. Risk of dust dispersion.