24
safety screw.
•
Place the Water Tank on the Humidifier Power Base.
•
Connect the Mist Delivery Hose to the Mist Outlet and the Cap of Water Tank.
•
Place the Cap of Water Tank on the Water Tank.
•
Insert 2 x AAA size batteries (not supplied) into the remote control.
•
The 40cm Pedestal Mist Fan is now ready to use.
OPERATING THE MIST FAN
•
Remove the Water Tank from the Humidifier Power Base, turn it up-side down and you
will see a small plastic cover.
•
Open the cover by turning it in a counter-clockwise direction.
•
Fill the Water Tank with clean water.
•
Close the plastic cover by tightening it in a clockwise direction. Note that there is a white
silicone ring which must not be loosened when filling the Water Tank with water.
•
Place the Water Tank back onto the Humidifier Power Base.
•
Plug the Mist Fan into the mains electrical supply. A
“
beep
”
sound will be heard indicating
that the Mist Fan is connected to the power.
•
The
“ ”
indicator light on the Main Control Panel will illuminate.
•
Now the Mist Fan can be switched on either on its Main Control Panel or by the Remote
Control.
•
Press the
“
button to switch the Mist Fan on.
•
By default, the Mist Fan will be switched ON in
−
Low Speed Setting,
−
Fixed Direction and
−
Normal Wind mode setting
•
After switching on the Mist Fan you can select different Speed Settings or the Wind Mode
that you prefer.
•
The table below shows which switches perform which speed and wind functions:
