Jocel DW5A, Руководство по обслуживанию

Страница: 7 / 12

If switch trouble is suspected, check whether the dishwasher is level. If it is in level
position, remove the outer casing.Add water to the inner container, and check whether
the float and lever is choked.In case of choking, correct it.If the dishwasher does not
work when the water level is over 92mm, the switch might be obstructed or the motor
wring is wrong connected
. Please replace it or Repair the motor wiring .If the protection
switch remain placid when the water level is over 5mm below the brink of the inner
container, the floater base and the filter might be blocked orthe floater base is too dirty
cause the floater is sticked.Please clean the filter,floater ang floater base.
XI. Inlet Valve
The inlet valve controls the water volume into the dishwasher. The electromagnetic valve
is fixed on the valve base. When it is powered, a magnetic field will come and pull the
valve core to let in the water. The feeding of the water depends on the electrical
controller, which controls the opening of the electromagnetic valve. In normal
circumstance, the water leve in the inner container of the dishwasher shall be 88-92mm
above the sump bottom. Open the door to check the water leve when water is filled.
During the washing operation, the inlet valve may open to add some water.
Removal and replacement:
Check and replace the inlet valve.
ٛ
a. Turn the power of the dishwasher to OFF, and pull out the power cord plug
(guard against sharp edge from hurting the power cord).
ٛ
b. Check with an ohmmeter as instructed.
ٛ
c. Remove the outer casing and the rear panel.
ٛ
d. Check the connecting wire of the inlet valve for looseness and the valve for
crevice.
ٛ
e. Check the connection of the inlet hose.
ٛ
f. If the incoming pressure in the water tank is lower than the normal level, remove
the inlet hose, clean, or, if necessary, replace the filter screen, and reconnect the
inlet hose.
ٛ
g. Check the inlet valve terminals with an ohmmeter. The probes should touch the
terminals of the inlet valve. If the pointer does not move, replace the inlet valve with a
new one.
ٛ
h. When replacing the inlet valve, turn down the water tap and remove the clamp
and the connecting tube.
ٛ
j. Unscrew the screws in the inlet valve support replace the inlet valve with a
new one, and reconnect the tube and wire. Connect the inlet hose when the dishwasher
is ready.
XII. Washing Pump Motor Assembly
Water Pump Motor Assembly The dish washing is a joint accomplishment of the washing
pump assembly and the drain pump . The possible troubles of the washing pump
assembly include motor damaged, motor capacitor damaged, damaged pump sealing
spring, broken sealing, broken connecting tube, etc.
Steps for the check:
ٛ
a. Turn the power of the dishwasher to OFF, and pull out the power cord plug.
ٛ
b. Remove the outer casing, and turn the dishwasher upside down.
ٛ
c. Remove the connecting screws around the bottom panel and the screws to the
motor support, the drain motor and the pressure switch bracing bar.