4
Using Speaker Selectors with IM
Muting Volume Controls
We recommend using the JobSite V-T4M muting
volume control connection terminal to connect the
V-12M and V-12M/AWE muting volume controls to a
system. If you choose not to use a V-T4M
connection terminal, you must provide 12 volts to
each muting volume control for the muting circuit to
work. We do not recommend using Speaker
Selectors with Muting Volume Controls.
The programmable muting feature serves the same
purpose as an On/Off switch on a Speaker Selector
Tools Required
n
1/8" Slotted screwdriver
n
1/4" Slotted screwdriver
n
No.2 Phillips screwdriver
n
Wire stripper
n
Wire labels
INSTALLATION
V-12M
1. Identify the Speaker wire, V-T4M connection
terminal wire and 12V wire. Label the wires for
future reference.
2. Strip 1/4" of insulation from the end of each wire.
Tightly twist the end of each wire until no frayed
ends remain.
3. Locate the Snap and
Lock connectors and
remove them if they are
plugged in.
See figure 5.
4. Use a small flathead
screwdriver or your
thumb to raise the locking
tabs, exposing the holes on the connector.
5. Insert each wire into the appropriate hole and
snap down the locking tabs.
Figure 5
