PREPARING FOR INSTALLATION:
The IR-FMR MKII Receiver cable must reach the proposed location of the IR
connecting block. If not, use CAT- 5 cable to extend the length. Mark the cable with
a wire label, describing where the cable originates from, rather than where it will
terminate. Verify there are 3 inches (76.2 mm) of clearance behind the surface where
you plan to mount the IR-FMR MKII.
INSTALLATION:
1. Determine a mounting location for the IR-FMR MKII.
2. Drill a 1/2” (12.7 mm) hole where the IR-FMR will be mounted.
3. Secure the IR-FMR MKII by tightening the hex nut. DO NOT OVER-TIGHTEN.
4. Run the IR-FMR MKII cable. Label the cable for future reference
5. Strip 1/4” (6.4 mm) of insulation from the end of each CAT-5 wire.
6. Locate the IR connecting block snap and lock connectors and remove them
if they are plugged in
7. Use a small flathead screwdriver or your thumb to raise the locking tabs,
exposing the holes on the connectors
8. Insert each wire into the appropriate hole and snap down the locking tabs
9. Insert the smooth side of the connector plug into the smooth side of the
IR connecting block socket
IR-FMR MKII INSTALLATION DIAGRAM
12VDC/
OUTPUT
HI
LOW
HI
LOW
1
1
2
2
3
5
4
EMITTER OUTPUTS
POWER
+12V DC
IR RECEIVER INPUTS
3-30V
AC/DC
STATUS
IN
IR-CB2
IR CONNECTING BLOCK
Stereo Receiver
12V DC Power Supply
(not supplied) plugged into
the Switched outlet
12V DC power supply
plugged into an unswitched
AC outlet powers the system
IR-CB2
JobSite
IR-E1
Emitter
IR-FMR MKII
LCD/PLASMA-PROOF FLUSH MOUNT IR RECEIVER
IR-FMR MKII
JOBSITE SYSTEMS
12331 SW 130 STREET
MIAMI, FL 33186
P
866.4JB.SITE (866.452.7483)
F
305.238.0185
WWW.JOBSITESYSTEMS.COM
©2007 JobSite Systems. All rights
reserved. JobSite, Pure Custom and Niles
are registered trademarks of Niles Audio
Corporation and the JobSite Logo is a
trademark of Niles Audio Corporation. All
other trademarks are the property of their
respective owners. CS0168A
Specifications subject to change without notice.
Содержание IR-FMR MKII
Страница 4: ......
