ONE ZONE IR CONNECTING BLOCK
IR-CB1
PREPARING FOR INSTALLATION:
The IR Receiver cables, Emitter cables and the 12V DC power supply cable must
all reach the proposed location of the IR-CB1 connecting block. Mark the cables
with Wire labels, describing where the cables originate from, rather than where
they will terminate. Locate a local un-switched AC outlet to be used to power the
IR-CB1 power supply.
INSTALLATION:
1. Run all the necessary wiring to the IR-CB1. Label the wires for future
reference.
2. Plug the supplied 12V DC power supply into the un-switched AC outlet.
3. Plug the 12V DC power supply connector into the IR-CB1 socket marked
POWER.
4. After verifying that the AC outlet works, unplug the power supply connector.
5. Strip 1/4" of insulation from the end of each CAT5 wire.
6. Locate the Snap and lock connectors and remove them if they are plugged in.
7. Use a small flathead screwdriver or your thumb to raise the locking tabs,
exposing the holes on the connectors.
8. Insert each wire into the appropriate hole and snap down the locking tabs.
9. Insert the smooth side of the connector plug into the smooth side of the
IR-CB1 socket.
10. Connect the Emitters to the Emitter outputs.
11. Plug the 12V DC power supply connector into the IR-CB1 socket marked
POWER.
IR-CB1 INSTALLATION DIAGRAM
1
23
4
POWER
+12V DC
EMITTER OUTPUTS
IR-CB1
IR CONNECTING BLOCK
IR RECIVER INPUT
3-30V
AC/DC
STATUS
IN
IR-CB1
Stereo Receiver
12V DC Power Supply
(Not Supplied) plugged into
the Switched Outlet
12V DC Power Supply
Plugged into an Unswitched
AC Outlet Powers the System
IR-WMR
JobSite
IRE1
Emitter
JOBSITE SYSTEMS
12331 SW 130 STREET
MIAMI, FL 33186
P
866.4JB.SITE (866.452.7483)
F
305.238.0185
WWW.JOBSITESYSTEMS.COM
©2004 Niles Audio Corporation. JobSite,
Pure Custom and Niles are registered
trademarks of Niles Audio Corporation
and the JobSite Logo is a trademark of
Niles Audio Corporation. JSIRCB1PDF
Specifications subject to change without notice.
Содержание IR-CB1
Страница 4: ......
