roller stand or a work surface that is level with the saw
table.
8.
Before turning on the saw, perform a dry run of the
cutting operation to check that there are no problems
such as a clamp interfering with the cutting action.
9.
Hold the operating handle (5) and firmly and squeeze
the
release latch
(30)
. Allow the blade to reach
maximum speed and slowly lower the blade into and
through the workpiece.
10.
Release the switch trigger (19) and allow the saw
blade to stop rotating before raising the blade out of the
workpiece. Wait until the blade stops before removing
the workpiece.
To Slide Cut Wide Boards
To slide cut wide boards,
Unlock the slide lock knob (24)
and allow the cutting head assembly to move freely.
SETTING CUTTING DEPTH
The depth of cut can be preset for even and repetitive
shallow cuts.
1.
Slide the stop plate
(24)
towards the front position.
2.
Loosen the lock nut
(25)
to free the lock knob
(23)
,
turn the stop knob until the cutting head down until the
teeth of the blade are at the desired depth.
3.
While holding the upper arm in that position, tighten
the lock nut to secured the stop knob.
4.
Recheck the blade depth by moving the cutting head
front to back through the full motion of typical cut
along the control arm.
TO
REMOVE
OR
INSTAL BATTERY
PACK
WARNING:
Never outlet the battery pack while
the tool is working.
Depress the battery pack lock button to release
and slide the battery pack out from your tool.
After recharge, slide it back into your tool. A
simple push and slight pressure will be
sufficient.
CHARGING THE BATTERY PACK
1. The battery charge supplied is matched to the
battery installed in the machine. Do not use
another battery charger.
2. The battery pack is protected against deep
discharging. When the battery pack is empty, the
machine is switched off by means of a
protective circuit.
3. Connect the charger to the power supply and the
power on LED indicator lights will showing. Slide
the battery pack into the charger to make the
connections.
BATTERY POWER CHECK
Before working, press the
ON
button which is at
battery surface, it will active battery and
showing battery power several seconds.
MAINTENANCE
1.
Store the tool, instruction manual and accessories in a
secure place. In this way you will always have all the
information and parts on hand.
2.
Keep the tool
’
s air vents unclogged and clean at all
times.
3.
Remove dust and dirt regularly. Cleaning is best done
with compressed air or a rag.
4.
Never use caustic agents to clean plastic parts.
GENERAL INSPECTION
1.
Regularly check that all the fixing screws are tight.
They may vibrate loose over time.
SERVICE
•
Tool service must be performed only by qualified
repair personnel. Service or maintenance performed by
unqualified personnel could result in a risk of injury.
•
When servicing a tool, use only identical replacement
parts. Follow instructions in the Maintenance section of
this manual. Use of unauthorized parts or failure to
follow Maintenance Instructions may create a risk of
electric shock or injury.
Содержание CT5305
Страница 14: ......
