Jobsite CT0092, Оригинальное руководство

Страница: 13 / 17

▪ After switching on the saw, wait for the blade to
reach its maximum speed.
▪ Press the release lever sideways and, using the
handle, apply steady and light downward pressure
to move the machine head through the workpiece.
▪ When the cut is completed, return the machine
to its top parking position and let go of the On/Off
switch.
Caution! A return spring causes the machine head
to rise automatically at the end of the cut.
Do not let go of the handle as soon as the cut is
completed but steady the machine head and allow it
to rise slowly.
Laser
▪ The laser directs a beam onto the workpiece
▪ Extremely precise cuts can be made using the
laser function.
Dust bag
To attach the dust bag, fit it onto the dust extraction
adapter. When the dust bag is about
half full, remove the dust bag from the tool and
empty it.
Sawing
▪ Clamp the work piece firmly.
▪ Set the required horizontal mitre angle or the
required vertical bevel angle.
▪ Switch on the power tool.
▪ Move the handle slowly downwards.
▪ For long workpieces you should use the slide;
loosen the locking knob for this purpose.
▪ Saw trough the work piece.
▪ Switch off the power tool.
▪ Wait until the saw blade has come to a complete
standstill before removing the work piece.
Sawing special work pieces
Curved or round work pieces need to be secured
against slipping.
Make sure there is no gap between the work piece
and the fence or the saw table.
Replacing the saw blade
▪ Press the release lever and fold up the
removable blade guard.
▪ Press the spindle lock knob to activate it, turn
the saw blade by hand until it
locked.
▪ Loosen the blade lock bolt by turning it
clockwise using the Allan key.
▪ Remove the lock bolt, outer flange, saw blade
▪ Remove the chips or sawdust from around the
spindle and flanges.
▪ Fit the new saw blade, flanges and lock bolt.
Check that the blade rotation direction
complies with that of the motor.
CLEANING AND MAINTENANCE
Service
Only qualified specialist personnel and original
replacement parts should be used for repairs. This
will ensure that your device remains safe.
Cleaning
▪ Regularly clean the machine housing with a soft
cloth, preferably after each use.
▪ If the dirt does not come off use a soft cloth
moistened with soapy water.
▪ Never use solvents such as petrol, alcohol,
ammonia water, etc. These solvents may
damage the plastic parts.
Lubrication
The machine requires no additional lubrication.
Checking and replacing the carbon brushes
The carbon brushes must be checked on a regular
basis.
_ Remove the carbon brush holders and clean the
carbon brushes.
_ In case of wear, replace both carbon brushes at
the same time.
_ Mount the carbon brush holders.
_ After mounting new carbon brushes, let
the machine run at no load for 15 minutes.