Jobsite BRUSHLESS CT5650, Инструкция по эксплуатации

Страница: 15 / 21

13
Sanding stained edges
Sanding of thermoplastics
7. MAINTENANCE
WARNING: Always disconnect from the power supply before carrying out any
inspection, maintenance or cleaning.
GENERAL INSPECTION
1. Regularly check that all the fixing screws are tight.
2. Inspect the supply cord of the tool, prior to each use, for damage or wear.
3. Repairs should be carried out by an authorised service centre.
CLEANING
WARNING: Always wear protective equipment including eye protection and
gloves when cleaning this tool.
1. Keep your tool clean at all times. Dirt and dust will cause internal parts to wear
quickly, and shorten the device
’
s service life.
2. Clean the body of your machine with a soft brush, or dry cloth.
3. Never use caustic agents to clean plastic parts. If dry cleaning is not sufficient,
a mild detergent on a damp cloth is recommended.
4. Water must never come into contact with the tool. Ensure the tool is thoroughly
dry before using it.
5. If available, use clean, dry, compressed air to blow through the ventilation
holes (where applicable).
LUBRICATION
Slightly lubricate all moving parts at regular intervals with a suitable spray
lubricant.
STORAGE
Store this tool carefully in a secure, dry place out of the reach of children.