Jobsite BRUSHLESS CT5650, Инструкция по эксплуатации

Страница: 12 / 21

10
6. OPERATION
1. The tool is intended to be operated as a hand held tool. The tool can be used
in any position. Note! The sander can develop a torque reaction when started.
2. Make sure the sander is switched off. Select a suitable abrasive and secure it
to the backing pad. Make sure the abrasive is centred on the sanding pad. For
optimal performance we recommend original sanding pad and Sanding paper.
3. Switch on the sander by pressing the On/Off key,
4. The sander can now be started by pressing the lever.
5. The speed can be adjusted between 4,000 and 10000 rpm by rpm+ and rpm-.
Each press increases or reduces the speed by 1,000 rpm until it reaches the
limits.
6. When sanding, always place the tool on the work surface before starting the
tool. Always remove the tool from the work surface before stopping it. This will
prevent gouging of the work surface due to excess speed of the abrasive.
7. When sanding is finished, turn off the sander by pressing the On/Off key. The
sander LED (right) is now turned off.
Replacing the sanding pad
Always disconnect the power before maintenance! Only use original
sanding pad!
1. Insert the pad wrench between the backing
pad and brake seal to hold the spindle nut.
(see Fig.1)
2. Turn the backing pad counterclockwise to
remove it.(see Fig. 2)
3. Fit and tighten the new backing pad with
washers. (see Fig. 3)
4. Remove the pad wrench.
F
ig.1
F ig.3
F ig.2