Jobsite 7201-S2, Инструкция по эксплуатации

Страница: 10 / 16

7
The recommended values for the thickness and
the hole diameter must be observed for cutting
discs that are fitted with flat flanges.
When fitting a cutting disc the shaft screw must
only be tightened so far that the disc is secure
and cannot turn by itself. If you tighten the shaft
screw to much, the cutting disc may jump off the
disc flange or the disc may fracture.
After fitting a new cutting disc allow the machine
to run for approximately one minute before
starting any cutting work. Do not stand in the
cutting direction of the machine during this
process. If the disc has an invisible fracture or
some other type of damage that it not obvious, it
will rupture in less than one minute.
Check the cutting disc at regular intervals for
signs of damage and possible cracks. Replace any
such damaged or cracks cutting discs without
delay.
Use only cutting disc flanges that are suitable for
use with this machine.
Ensure that the cutting disc moves easily before
you switch on the machine.
Allow the machine to accelerate to maximum
speed before starting any cutting work.
Always lower the cutting disc on to the workpiece
slowly.
Prevent the cutting disc from fluttering or
jumping. This will result in poor cutting results,
premature wear or even to the fracture of the
cutting disc.
Keep the angle of the cutting disc to the
workpiece as low as possible.
Never cut without the cutting disc cover.
In the event that a mechanical part is missing
from your machine, is damaged, does not
function correctly or a component of the
electrical system has an error or is damaged.
Switch the machine off without delay, pull the
plug and have the error repaired straight away.
GB
You must comply with all the other general safety
regulations and the relevant accident prevention
regulations.
Machine components
1. Handle
2. ON/OFF switch
3. Carry handle
4. Carbon brush cover
5. Interlock
6. Cutting depth screw
7. Cutting depth nut
8. Angle guide
9. Vice
10. Base plate
11. Vice crank
12. Quick clamping lever
13. Cutting disc
14. Movable guard
15. Spindle lock
16.Locking button
Before starting
Please note that the tool must be placed in a
stable position on a workbench or on bolted to a
solid sub-frame.
Before starting the machine, check that all covers
and safety equipment are correctly fitted.
Ensure that the cutting disc moves easily.
Before you switch on the tool, ensure that all the
moving parts move easily and that the cutting
disc is installed correctly.
Before connecting the tool to the power supply,
ensure that the data on the rating plate are
identical to the mains data.
Assembly
Important. Disconnect the machine from the
mains supply before starting any setting,
assembly and servicing work.