jobmate JMCDI218GB.1, Инструкция по безопасности и эксплуатации, Страница: 8 / 16

8
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book
carefully.
INTENDED USE
The machine is intended for driving in and loosening screws
as well as for drilling in wood, metal and plastic.
The machine is also intended for impact drilling in brick,
concrete and stone as well as for drilling in wood, metal and
plastic.
CHARGING PROCEDURE
Before putting into operation
Charging the tool or battery pack (See Fig A)
NOTE:
a) The battery in your new tool is not charged when it
leaves the plant. Therefore it must be full charged before
using the first time.
b) Do not use any charger other than that specifically
provided for use with the equipment.
c) If the battery pack is very hot you must remove your
battery pack from the charger and allow time for the
battery to cool down before recharging.
d) Please charge the battery to reach full or no less than
half charge before storage. If The tool will not be used for
long periods of time, charge the battery every 3-6 months
1).plug the charger into an appropriate outlet.
2).place the battery pack into the charger
3).when charging is completed, unplug the charger and
remove the battery pack.
NOTE: If the battery pack is locked in the charger, press the
battery pack release button and remove it.
WARNING: When battery charge runs out after
continuous use or exposure
To direct sunlight or heat, allow time for the battery to cool
down before recharging to achieve the full charge.
Light ON/OFF flash Status
Green flash
- - - - - - Charging
Green on
Fully charged
INSTALLING AND REMOVING THE BATTERY PACK (SEE FIG
B1, B2)
a) To remove the battery pack
Press the battery pack release button(10) firmly fist and slide
the battery pack out from your tool.
b) To install the battery pack
Slide the fully charged battery pack onto the tool with
sufficient force until it clicks into position.
Fig.A
Fig.B1
Fig.B2
Fig.C
Fig.E2
Fig.E1
Fig.D
Fig.H
Fig.G
Fig.F
Fig.J1
Fig.I
Fig.J2