jobmate JMCDI218GB.1, Инструкция по безопасности и эксплуатации, Страница: 12 / 16

12
authority for information regarding available recycling and/
or disposal options. Discharge your battery pack by operating
your drill, then remove the battery pack from the drill housing
and cover the battery pack connections with heavy-duty
adhesive tape to prevent short circuit and energy discharge.
Do not attempt to open or remove any of the components.
13 OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve the
load on the machine immediately and allow cooling for approx.
30 seconds at the highest no-load speed.
14 TEMPERATURE DEPENDENT OVERLOAD PROTECTION
When using as intended for the power tool cannot be subject
to overload. When the load is too high or the allowable
battery temperature of 75 °C is exceeded, the electronic
control switches off the power tool until the temperature is in
the optimum temperature range again.
15. PROTECTION AGAINST DEEP DISCHARGING
The Li-ion battery is protected against deep discharging by
the “Discharging Protection System”. When the battery is
empty, the machine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
16. HOW TO USE THE BELT CLIP (SEE FIG.J1 J2)
Screw the Belt clip(8) on the tool with the screw (not
provided). The Belt clip can be hooked on your belt or pocket,
etc.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON WHEN YOU
PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of the
trigger, is positioned in the lock function. Unlock the forward/
reverse rotation control by putting it into the required
rotation position. Push the trigger and the drill will start to
rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS COMPLETELY
TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring, you
can find the torque-adjusting ring between the chuck and the
drill body. Position 1 is the lowest torque (screw driving force)
and position 21 is the highest torque (screw driving force).
Position is for drill operation. Regulate the torque adjusting
ring to a higher position to reach the best result.
Fig.A
Fig.B1
Fig.B2
Fig.C
Fig.E2
Fig.E1
Fig.D
Fig.H
Fig.G
Fig.F
Fig.J1
Fig.I
Fig.J2