14
INSTALLING THE GUARD
– cont’d
6. Rotate guard to position it toward the
rear of the grinder.
7. Use a #2 Philips
®
screwdriver to
tighten the guard clamp screw (Fig. 4).
8. Install the disc flange, making sure it
mates with the flats on the spindle.
9. Install the clamp nut finger tight to
hold the disc flange in place.
INSTALLING A GRINDING DISC
WARNING:
Use correct size
grinding disc. Never use a grinding disc
thinner than 5/32"(3.9mm).
1. Depress the spindle lock button (1)
and rotate the clamp nut (2) until
spindle locks (Fig. 5).
2.
Turn the clamp nut counter clockwise
and remove it from spindle.
NOTES:
a) If the clamp nut cannot be loosened by
hand, use the wrench (3) provided.
b) DO NOT remove the disc flange (4).
3. Make sure the flats on the bottom of
disk flange are engaged with the flats
on the spindle (5).
4. Place the grinding disc over the
spindle with the concave side of the
disc (6) facing outward.
ASSEMBLY AND OPERATION
!
