Joab EcoDrive VL10U, Руководство по эксплуатации и обслуживанию

Страница: 28 / 57

Start the Radio Controller
To start the radio controller, follow the procedure listed below:
1. Make sure that the activation button is pulled out.
2. Press and hold down buttons 11 and 12 simultaneously until a bleep is heard.
3. Verify that the display turns ON.
Fast Operation
To activate fast operation using the control panel, first operate the lifting-arm out and then
press and hold button 11.
Fast operation functions automatically when using the radio controller, simply press button 1
on the radio controller. The buttons on the radio controller are analogue and fast operation is
initiated when the button is 90% pressed.
NOTE: fast operation will not activate if the skip load is too heavy. This is a safety feature. If the
weight of the load causes the pressure in the lifting cylinder to be greater than 70 bar, fast oper-
ation is automatically disabled.
Axle Weight
The radio controller can be used to provide an approximate value for the weight
on an axle(s). Note, this is not a precise value and must be seen as an indication
of the actual weight only.
JOAB AB disclaims all responsibility if a vehicle is over weight, even if the radio
controller displays a value that is lower than the maximum allowed for the
vehicle
.
The value displayed in the radio controller will normally be within ± 150 kg.
To use the axle weight function, activate Function_4 mode. A weight scale is
shown in the display. To select which axles are included in the measurement,
press the respective buttons: 2, 4, 6, and 8 corresponding to the axle(s) that are
to be measured.
Each of the buttons (2, 4, 6, and 8) have two LEDs above them. These are used to show which
axles are selected and the status of the axles. The right LED is illuminated red for axles that
are selected, as shown. The left LED will blink red whenever an axle is 0–500 kg less than the
maximum allowed weight. The left LED will constantly illuminate if an axle is over its allowed
weight.
The LED above button 9 is used to indicate that it is the net weight that is displayed in the
screen. When the net weight is displayed, the LED is lit red. To change between the net weight
and the gross weight press button 9.
22
Radio Controller | Operation
EcoDrive VL10-VL18 manual: 1021046 Edition 2 | 2022-05-02