Joab EcoDrive LA, Руководство по эксплуатации и обслуживанию

Страница: 35 / 89

To deactivate the CMS position, simply press the respective CMS icon to turn it off. Altern-
atively, it can be temporarily overridden. To do this, press and hold down the hydraulic-lock
open icon
while operating the extending-section. This can also be done with the use of
JOAB's radio controller. To do so, simply press and hold down the hydraulic lock open button
on the radio controller while operating the extending-section. Refer to
"Radio Controllers", on
page 35 .
NOTE: The two CMS stop positions are set during manufacture to default values. The set pos-
itions can vary depending on the length of the hook-lift. Any changes made to the set positions
will be saved, even if the system is shut down and restarted.
NOTE: If CMS is active when the system is shut down, it will also be active when the system is
restarted.
Active Plough Control - APC
There is a serious risk of injury or death when operating or working on a vehicle with
a snow plough. This is particularity important to bare in mind when the
Automatic
plough up function is activated. The ploughs are automatically retracted when the
vehicle is put into reverse gear. Make sure there are no persons near the ploughs
when operating the vehicle or ploughs.
The CBW controller can be equipped with functions for controlling snow ploughs - APC. These
functions allow the driver to control both a front and side snow plough. APC is able to work with
both fixed and variable pumps.
It is also possible to install an external plough that is operated by its own control unit. For
information about this refer to
"External Plough Systems", on page 33 .
As an extra option, APC can also be controlled using JOAB's remote radio controller or JOAB's
wired remote controller. Both these allow the operator to control the loading and unloading of
ploughs while having a good visual overview of the process. For further information regarding
the radio controller, refer to
"Radio Controllers", on page 35 . For further information regarding
the wired remote controller, refer to JOAB Online Manuals - Accessories .
The CBW controller can be installed on the driver's arm rest, which is ideal for APC. Refer to
"Appendix 2 - APC Transfer Kit ", on page 79 for further information about this. Alternatively, an
additional control-stick can be installed on the driver’s arm rest. The additional control-stick
can only be used to control the APC, not the hooklift.
Control-Stick Functions
Provided below are the functions for vehicles that have APC installed. To activate these func-
tions the user interface must be in the snow plough page setup
and the pump turned off.
Refer to "Page Setups", on page 14 .
Once the snow plough page setup has been activated, it is then possible to operate the snow
ploughs using the control-stick. Simply push the control-stick forward to lower the front snow
plough. To lower the side plough, simply press the top button, as shown below in Table 7.
27
Operation | EcoDriveOptional Functions
EcoDrive 2.0 manual: 1021970 Edition 1 | 2022-02-04