三、
installation guide
Installation hint: to eliminate the installation error, please do not fully tighten the
bolt of each step, such as the machine after the installation is complete,
then tighten all bolts completely
!
1、
riser
:
●
Upward of riser and electronic part, the front
with the M8 4 x 15 screws and washers, two
side with the M8 x 45 screw 2 with gasket
and tighten
2、
Electronic watch: using M8 2 x 15 screws,
and washers through the arrow shown in
place, and tighten.
3、
U tube and function
Gasket with M8 4 x 70 screw, respectively
through the stand pipe connected to the U
pipe thread hole and tighten
。
Gasket with M8 x50 screw 2 4, nut 2, through the
function frame and u-shaped tube hole to
tighten connection
4、: massage:
Massage machine under the first three
screw screw down, then head on function
frame plate of well hole, tighten plucked
screws to mount on a massage belt.All the
install screws to clean again, confirm the
screws are tight.
5、
About set cover of the management
Use 4 pcs m10*5 screw、
Around the
shield and riser respectively
corresponding to the lock hole and
tighten
。
6、 key:
Plugged in, turned on the power switch and
then put the safety lock in digital watches
as shown in figure position, press the
START button (START), you can START
running (note: beginners START from low
speed to adapt to)
。
-5-
key