Low add lubricant step: (as pictured)
1. Stop running belt, the folding machine;
(2) take the frame on the back of the run wave;Took oil can reach as far as possible into the run middle
3. Run an elastic adjustment
All the running machine in the factory before and after installation to adjust running belt, but after using a
period may also appear relaxation phenomenon.Such as: the user to pause the phenomenon of sliding at
running.When appear this phenomenon, in a half circle clockwise, synchronous adjustment to run around with
adjusting bolts.Run with too loose, foot in running, running belt and roller turn produce skid phenomenon, but
too close is not good, easy to increase the load of the motor, damage to the motor, running belt and roller, etc.
4. Run belt running deviation adjustment
The treadmill has been adjusted and passed QC inspection before leaving the factory. If there is
phenomenon of bias running of the belt, the possible reasons might be:
A. The frame is not stably laid
B. The user is not running on the centre of the running belt;
C. The user’s two feet are not using even strength.
For bias which can not be fixed automatically, try the following methods to fix the belt, as picture shown
-9-
A
B
C
If the belt tends to move to the right, you should turn the
belt adjustment screw on the right in clockwise
direction. We recommend you turn 1/4 turn each time
and check how it works. If the belt remains slanting to
the right ,then turn the belt adjustment screw on the left
in counterclockwise direction 1/4,as shown in the
picture A
If the belt tends to move to the left, then turn the belt
adjustment screw on the left in clockwise direction for
1/4 turn. If the belt remains slanting to the left ,then turn
the belt adjustment screw on the right in
counterclockwise direction for 1/4 turn, as shown in the
picture B
After having been used for a period, the belt might be
slightly elongated, and slipping and halting might appear
when a person is running on it. When these phenomena
appear, you should secure the screws on both sides for
1/4 turn. If the belt is too tight just loosen the screw on
both sides for 1/4 turn, as shown in pict
ure
c.
