USAGE
For Cleaning up small, dry particles and debris from hard and upholstered surfaces
(countertops, desks, tables, tile and wooden floors, low-moderate pile carpeting,
sofas, chairs, blankets, leather surfaces, car interiors, bags and suitcases.
Works great on the following: crumbs, sugar, salt, pepper, sprinkles, coffee grounds,
baby formula, glitter, pencil shavings, dried play dough, dirt, sand and ice-melt.
OPERATION
Installing batteries
1. Open upper dome housing by rotating
it counter-clockwise. Indicator line on
edge of dome housing should move
from “CLOSE” to “OPEN” (see Fig.1).
To replace the dome housing, rotate
back into position clockwise to ‘CLOSE’.
2. Install 2 x 1.5V AA batteries following
the indicated polarity (see Fig. 2).
3. Replace upper dome housing.
Fig. 1
Fig. 2
Turning ON/OFF
1. Use thumb (or finger) to slide power switch located on
side of unit from “OFF” to “ON” (see Fig. 3).
Emptying/Cleaning
1. Remove base cover by pressing tab labeled “PUSH”
while tilting base cover downward to separate it from
upper housing (see Fig. 4).
2. Remove filter assembly by simply pulling it out of upper
housing. It will “snap” free to expose the motor turbine.
Fig. 3
MAINTENANCE
1. Empty debris particles from base cover into trash after each use for best
performance.
2. Completely remove base cover and filter assembly from unit for cleaning. Rinse
base cover and filter under warm water to clean leftover particles and residue.
Make sure cover and filter are completely dry before reassembling.
3. Do not expose upper housing or motor components to water. These components
should be cleaned using only compressed air or a small brush if needed.
4. If a decrease in cleaning performance is noticed, empty base cover, check for
blockages, and replace batteries if need be.
CCC_IM_A.indd 3-4
16/04/2018 16:13
