Continued on Next Page
SB-GM-TAHOSCNSL/10W1v3_INSTR_SKU#011220
S T E P 2 1 B
This is the passenger’s side tab.
S T E P 2 1 A
The rear of the Stealthbox® is to be fitted between a pair of
tabs that are protruding up from the flooring.
This is the driver’s side tab.
S T E P 2 0
The front of the Stealthbox® fits against the black plastic
panel located on the passenger side.
S T E P 1 9
Position the Stealthbox
®
in the mounting location.
Page 5 • JL Audio, Inc 2016
S T E P 2 3
Note: Before drilling, make sure that you are not
going to be drilling into any gas lines, brake lines,
transmission lines, electrical wiring, transfer case
(4x4 vehicles) or anything else that might cause
a reduction in your weekly pay. Always wear eye
protection when drilling!
With a drill and a 1/2-inch drill bit, drill through the
impression made in the wax square and into the vehicle’s
transmission tunnel.
Remove the wax squares and the tape.
S T E P 2 5
Place the Stealthbox
®
into position by guiding the socket cup
set screws through the holes drilled in
Step 23
.
S T E P 2 4
Run speaker wire from the amplifier’s location to the
Stealthbox
®
location and check for proper operation of
the woofer.
Back out the socket cup set screws installed in
Step 18
, to
expose 1 1/4-inch.
S T E P 2 2
Once the Stealthbox
®
is in the mounting location, press
down on it firmly.
Remove the Stealthbox
®
carefully, leaving the wax squares
in place. The socket cup set screws will leave impressions in
the wax.